mmagic
Mountain Magic Snow Machines
These work with the new factory 3 " we have them in 7 and 8 tooth
T3 Bent drive shaft
- Thread starter Grizzly4323
- Start date
These work with the new factory 3 " we have them in 7 and 8 tooth
- Staff
- #22
- Joined
- Oct 21, 2006
- Messages
- 48,008
- Reaction score
- 32,148
- Location
- Edmonton/Sherwood Park
- Website
- www.bumpertobumper.ca
no link or picture?
Caper11
Active VIP Member
Not doo drivers like most have said, either the shaft was damaged removing the drivers, or that's not the factory drive shaft off the T3 and it was swapped with a different sled than installed in the t3.
I wonder if a cocked bearing on the shaft would cause that as well???
It looks like that shaft is putting huge stress on the driveline, hope the chaincase didn't break.
Sent from my iPhone using Tapatalk
I wonder if a cocked bearing on the shaft would cause that as well???
It looks like that shaft is putting huge stress on the driveline, hope the chaincase didn't break.
Sent from my iPhone using Tapatalk
Last edited:
Similar threads
