Unnotified recall on 11 Etec's
- Thread starter filly55
- Start date
snopro
Active VIP Member
Lots of threads on this already. Most dealers have already contacted there customers.
- Thread starter
- #3
snopro
Active VIP Member
No problem. You have till 2015 to get it fixed and they recommend you are over 2000kms before getting the work done.
Ministik Man
Active VIP Member
No problem. You have till 2015 to get it fixed and they recommend you are over 2000kms before getting the work done.
Does that apply to the 600cc also or only the 800s
snopro
Active VIP Member
Just the 800's as there is no concern with the 600's.
puddle
Active VIP Member
No problem. You have till 2015 to get it fixed and they recommend you are over 2000kms before getting the work done.
Went in today with unrelated problem. Service chick told me 1000-2000 km is ideal. 1010 km on a 2010 Summit. Turple Bros. RD
maxwell
Active VIP Member
does not apply to 2010 summits 2011 only.
puddle
Active VIP Member
I was "schooled" by maxwell. I stand corrected. It is a 2011. Thanks.
Last edited:
MATTIAC
Active VIP Member
I talked to my dealer today and they just said bring it in at 2000k and they will do it. I also asked about the flash for the hesitation bogg at certain elevation and apparently it doesn't apply to us/can summits and freerides. Strange. Either way it will be flashed when they do my pistons to put the sled Into break in mode
Teth-Air
Active VIP Member
I complained that mine would not start 1 day, first time in 3000kms and the dealer said it is getting a new flash?? It already had the break in mode added with the pistons at 2500 kms.
Similar threads
