bubs
Active VIP Member
I had a leaking axle seal on my 04 660 Grizzly so we changed the seal and now I can't get the axle to seal properly.
Do you guys know if there is an alignment mark or do you just slide the axle back in to the diff. Also the cover that slides on over top of the diff was loose and wobbling and now that I pulled the axle out again it fell right off, is this just slid on or do I need to replace it.
And finally I tore both boots on that axle last week on a test ride to check if the diff was still leaking.
This is the first quad I've owned that had boots so I'm not sure how to change them, jsut cut the old ones off and slide new ones on or what is all involved?
Thanks for the help.
Do you guys know if there is an alignment mark or do you just slide the axle back in to the diff. Also the cover that slides on over top of the diff was loose and wobbling and now that I pulled the axle out again it fell right off, is this just slid on or do I need to replace it.
And finally I tore both boots on that axle last week on a test ride to check if the diff was still leaking.
This is the first quad I've owned that had boots so I'm not sure how to change them, jsut cut the old ones off and slide new ones on or what is all involved?
Thanks for the help.
