would you install a h.o. and non h.o. cylinder together on a motor install

[ktm144]

about to drop this motor in but cylinder's are 613852 and 923817

 

[CUSO]

NOOOOOH!!!
If they were from different motors, model wise, it won't last.

about to drop this motor in but cylinder's are 613852 and 923817

 

[ktm144]

so the non h o cylinder is ported and was told the h o exh port is 1.5mm lower so i think i will risk this install

 

[imdoo'n]

so the non h o cylinder is ported and was told the h o exh port is 1.5mm lower so i think i will risk this install

so??? why you ask the stupid question then.



different compression, cylinderburn pattern, different jetting, may workbut more than likely a time bomb with short fuse.


maybe go back and light up another and rethink your options. but in the end it's your money and your learning curve. seems people only learn one way.

 

[maxwell]

Lol BOOM.

 

[underdog]

So.... You come here..... Ask a question..... And then do opposite of what people say?

 

[ktm144]

so got the num to mikewell. shop says i could run cylinder's not saying who. i got input from you peep's and learning. cheap out is not good with a new crank and piston's. deep in revy and time to ride this bitch.

 

[ktm144]

found cylinder for 150, to bad maybe you coulda pulled me off boulder with a dead sled or laughed on the way by , woohahaha. i will be back on here with something, how bout revy dirt bike guide/exp ride

 

[BeachSled]

Is this in the same sled you are trying to sell in the classifieds ???

 

[ktm144]

that sled has gone to a new home.