Quits at 7000

[kakwa climber]

Hey guys just looking to see if I can get some help. My 13 pro with a silber falls on it's face when it hits 7200 rpm. Runs great starts to pull hard then falls to 5500 rpm. Feels like it goes into limp mode. No lights come on just dies. Any suggestions.

 

[WesG]

Check the power valve covers for oily mess. If there is any pull them and change the bellows and gaskets. Place to start looking.

edit: while there check that the hoses from the pv's are still hooked up and the solenoid works.

 

[kakwa climber]

Ok thanks. I was thinking power valves as well. Is there a way to yes the solenoid?

 

[Vance Matheson]

Ok thanks. I was thinking power valves as well. Is there a way to yes the solenoid?

would you like the service manual for that sled. and is it the silber with the bully dog system?

 

[kakwa climber]

Ya a service manual would be great. My email is jory@gpwins. Ca

It's a 13 kit without the bullydog

 

[Vance Matheson]

Ya a service manual would be great. My email is jory@gpwins. Ca

It's a 13 kit without the bullydog

my email wont let me attach it ...its almost 50mb....with a 25mb limit.
give me your cell number in a private message and i will get it to you

 

[007sevens]

pouched primary spring???

 

[polarisdragon800]

I would check the diaphragms in the power valves. Pull them out but leave the plastic covers on, push the spade or valve all the way in and hold your finger over the hole on the end of the cover, let go of the valve and it should drop about a 1/4 of an inch or so and stay their if the diaphragms are sealing.