M1000 Throwing code

[P_ZIZZ]

Hey guys I was just wondering if anyone can tell me what this code is on my 08 M1000. when I go wide open and then let out of it it flashes ECU 18. Not sure where to start on this one as the sled runs pretty good until I let out of it. Any help would be awesome!

 

[macronut]

Hey guys I was just wondering if anyone can tell me what this code is on my 08 M1000. when I go wide open and then let out of it it flashes ECU 18. Not sure where to start on this one as the sled runs pretty good until I let out of it. Any help would be awesome!

Hey there! code 18 is servo motor! Change it out, and be sure to check the servo cable for cracks and frays or squashing. Some guys re-route the cables if need be!

 

[P_ZIZZ]

Thanks!! That is what I found when I googled it but wanted to be sure! I have already checked the cables and cleaned the powervalves so I just need to swap the servo and roll!

 

[macronut]

Awesome! If after you change servo and it still codes, try another servo, several peeps have had this happen!


Sent from my iPhone using Tapatalk