donbrownz
Member
Okay we all hear about the hit and miss of belt alignment from various sled manufacturers.
One modification Ive seen in the past is to allow the secondary clutch to move along the jackshaft to compensate for some misalignment. (float the secondary)
But this only solves one axis of deflection. Hopefully it is enough to lower the heat and prolong belt life.
Other solutions are stiffening the rubber on the mounts to keep alignment but adding vibration to the sled and possibly to the rider.
Is the following solution viable OR will it add TOO MUCH WEIGHT?
Align the ENGINE , BOTH primary and SECONDARY clutches all mounted to the same RIGID frame and bolt to the frame via traditional rubber to sleds frame.
Maybe float the secondary to compensate for belt deflection from the clutches opening and closing. But I think a rigid identical frame should do it.
This should minimize belt heat issues.
This will shift the flex / out of alignment issues to the jackshaft , shaft from the secondary to the gears.
Split the shaft and add a Constant velocity JOINT like ones used on drive axles of a car , utv etc ? Misalgnment solved !!!
Constant-velocity joints (also known as homokinetic or CV joints) allow a drive shaft to transmit power through a variable angle, at constant rotational speed, without an appreciable increase in friction or play. They are mainly used in front wheel drive vehicles. Many modern rear wheel drive cars with independent rear suspension typically use CV joints at the ends of the rear axle halfshafts and increasingly use them on the drive shafts.
Or make the secondary a clutched point with a EASILY replaceable CV joint attached to the shaft?
Well ? Well ?
One modification Ive seen in the past is to allow the secondary clutch to move along the jackshaft to compensate for some misalignment. (float the secondary)
But this only solves one axis of deflection. Hopefully it is enough to lower the heat and prolong belt life.
Other solutions are stiffening the rubber on the mounts to keep alignment but adding vibration to the sled and possibly to the rider.
Is the following solution viable OR will it add TOO MUCH WEIGHT?
Align the ENGINE , BOTH primary and SECONDARY clutches all mounted to the same RIGID frame and bolt to the frame via traditional rubber to sleds frame.
Maybe float the secondary to compensate for belt deflection from the clutches opening and closing. But I think a rigid identical frame should do it.
This should minimize belt heat issues.
This will shift the flex / out of alignment issues to the jackshaft , shaft from the secondary to the gears.
Split the shaft and add a Constant velocity JOINT like ones used on drive axles of a car , utv etc ? Misalgnment solved !!!
Constant-velocity joints (also known as homokinetic or CV joints) allow a drive shaft to transmit power through a variable angle, at constant rotational speed, without an appreciable increase in friction or play. They are mainly used in front wheel drive vehicles. Many modern rear wheel drive cars with independent rear suspension typically use CV joints at the ends of the rear axle halfshafts and increasingly use them on the drive shafts.
Or make the secondary a clutched point with a EASILY replaceable CV joint attached to the shaft?
Well ? Well ?