2000- 600 edge issues

[alyce001]

Have a 2000- 600 edge that wont idle up to where it should be,I have turned the idle screw in all the way but the screw is bottoming out and still wont idle up,: any idea what I need to do to fix it? , It has mikuni flat side carbs thanks again

 

[taggart]

It may be the TPS, if it has one. Will it rev up with the throttle? Dose it run fine other wise?

 

[Polarblu]

open your throttle a bit and try screwing the idle screw in. You might just be running it into the actual slide. Also which screw are you using? you might be playing with your fuel air screw not your idle screw make sure it is having a direct physical effect on the height of your slide