You are talking about the 230-320/380 springs there. I was thinking of trying those.
First though,would the next step be to try a stock roller ? I have them and they weigh 5 grams less....
I also have a stock pu/ye primary spring from an 06 I can try...(160-230)
I am pretty sure that it is...
Anyone else have an experience with this? If i mash the flipper, it will very rarely hit 8200, usually it really bounces between 79-8000 with it held to the bar. If I roll it on slow-like then it does not want to seem to waver as much. I havent had a chance to do a long sustained pull but it...
What I've found:
needle-stock (9egy2-58) clip#3 with shim
mains-460 (stock is 470?) so already leaned out?
pilots-17.5-stock
air screws 1.5 trurns out.
Forgot to add sled also has full spi exhaust.
Also checked carb boots and reeds, all is good there.
With the pipe and the pods shouldn't I be...
Still trying to figure out a mid-range (5500-6500rpm) burble on my new-to-me sled that is really taking all the enjoyment out of it...
There is a timbersled intake on it and I've read that this will sometimes flow less air than the stock airbox. I feel like its running rich, I did a couple...
Went for a ride to 5000ft with a tank of fresh gas, definitely more responsive on the top end but still sputtering @ mid-range, plugs still black and oily, will raise a clip on the needle and report back.
Just picked up a 07 the other day. I know nothing about it other than it supposedly has a rebuilt engine with 100kms, it still had half a tank of 40:1. Smelled like full synthetic in the oil tank, and I put a half a jug of brp semi-syn in there. I did mix a little oil in with the gas as well...
What is the id of the lower rad hose? I need to order the proper size hose adapter....\Was going to go with the round digital Koso gauge, anybody using this one?
Have to replace injector pump on the truck, cant go to pick up a sled, anybody travelling down south next few weeks or so that could pick up a sled and bring to revie or kelowna? Have a few hundred for delivery...pm me for more details, thanx