Hey guys, buddy is working on his sled and cleaning his power valves, said he turned the servo clockwise and got the cables out, then went to re-install and had to turn the servo motor a little to get the cables back in (before he re-installed them), now he's wondering if he's somehow "uncalibrated" his servo motor for the PV opening. Said he turned it less than a 1/4 turn.
I know they self-calibrate or cycle by just turning I think but thought I would check with folks here. Does he need to "calibrate" the servo motor somehow or just re-install the cables and turn it until the cables are tight again and then go? any insight is appreciated.
Merry Xmas.
I know they self-calibrate or cycle by just turning I think but thought I would check with folks here. Does he need to "calibrate" the servo motor somehow or just re-install the cables and turn it until the cables are tight again and then go? any insight is appreciated.
Merry Xmas.