Veloci_Raptor660
Member
So here is the situation. I wanted to install a fuse block for all my accessories ( 2 warn offroad lights, BRP volt gauge) to run off so I didn't have them coming directly off my battery. So I used a light probe to test for a wire that had 12V at it when the ignition was on. I found a Brown wire with red tracer going to a white relay that was by the CDI. I spliced into this wire to use as a power source to run the accessories. Now I have no 4x4 and that white relay chatters when it is hooked up. I removed the splice so that it is back to stock form to troubleshoot.
So far I have replaced the three black relays and the white relay that are by the CDI and the 4x4 fuse. Any other Ideas would be awsome as I have no other ideas and off to the dealer she goes if I can't find the problem.
Thanks
So far I have replaced the three black relays and the white relay that are by the CDI and the 4x4 fuse. Any other Ideas would be awsome as I have no other ideas and off to the dealer she goes if I can't find the problem.
Thanks