summitguy
Active VIP Member
Ok so first ride out this weekend after sled sitting all summer . Ran good all last year!!
only things I did this summer was replace drive shaft bearing and seal adjust the track and pull out rave valves took a quick look and reinstalled ,,
problem im im have is 3/4 of the way up Chappell it bogged like it was running on one cylinder but it's fine
i try and make a pull up the hill and 1/2 up would bog down then pick back up rpms on the trail I can run clicker 6 and not over rev .
last year I ran #3
any help would be awesome
only things I did this summer was replace drive shaft bearing and seal adjust the track and pull out rave valves took a quick look and reinstalled ,,
problem im im have is 3/4 of the way up Chappell it bogged like it was running on one cylinder but it's fine
i try and make a pull up the hill and 1/2 up would bog down then pick back up rpms on the trail I can run clicker 6 and not over rev .
last year I ran #3
any help would be awesome