Recent content by cjm

Check out Highlifters web site,or arcticchat.com. High lifter has a pinned section on top in the arctic cat headings. Tonns of great info on clutch mods, snorkels Etc. Snorkels on a cat are pretty straight foreard. If your handy, should only take a couple hours. The hardest part on the new...

Make sure you are pulling perfectly straight on the axle. I have found with mine, that if you have nay angle at all, it will not want to come out. If you still can't get it out, there are a couple write ups on arcticchat.com or highlifter.com, in the arctic cat section.

Hey Hadster, how you feeling. Got a cost for you bike repairs yet. Hope all is well. (It's Chris, I was the one running the duct tape when you had a little mishap on the trail)

just had a quick question, i have an 09, 700 h1, with a poer commander, PCIII, and some clutch work. I was able to pull 6500RPM last year, and am now down to 5800. I have tried with lighter weights, and in low range, same results? do you think my valves are out, not enough fuel? any ideas...

I have an 09 700 h1, LOVE IT. It will run with anything out there. I am faster than most, and i can ride the mud with anything i have run into out there as of yet. I was a little behinde the yamis in the mud, but i was running smaller tires, this has now been recified.

Sorry, one more thing. I also have a Power Commander PC3. It is supposed to be the best for the 700h1, but i have not got it programmed correctly yet. It will fit your machine as well, and go well with aftermarket exhaust, and snorkels if you so desire.

hey, I have an 09 700 H1, and this is what i recomend. Option 1. Install Speedwerx 18g rollers, and 1mm shim in your primary, this will open your primary, and alow you to start off in a lower gear. you may have to shave the back side of your clutch housing behind your secondary, as your belt...

go to firebans.ca for all of your information

You may find some more specific information on cats at arcticchat.com. I am a member there as well, and the guys have alot of good specific advice for cats. Take a look.

Hey Rider, check your plug at wot. this will be the most conclusive indication. (with out an air monitor in your exhaust) Most units are set up from factory for sea level, as i am sure has been indicated here before. You can also check your plug at 25 and 50%. Chances are you were set up...

Rider. don't forget, I had the quiet core in when we went for a quick ride. It is consideraably louder with the core removed. I still like it, but I may go to something different, maybee Speed Werx. I am loosing too much low end torque with the compete free flow of the HMF. Once the revs...

A friend of mine is fairly hgih up in Arctic cat's world and he actually recomends the Ralphs in Calgary as well.

I have heard good things about the dealer in Hana, and have personally had good luck with the dealer in Camrose

is this the Medler from Stettler?