has anyone had problems with 2010 dragons?

71250ford

Member
Joined
Dec 14, 2008
Messages
19
Reaction score
0
Location
okotoks, alberta
i have a 2010 dragon with about 280 miles on it and had the check engine light and detination happen at about 200 miles. change the plugs and sled ran perfect all day. at the end of the day on the trail out about 70 miles later the check engine light came on again and was dettinating. sled was running normal temp and not overheating, running about 124 degrees no temp light or nothing. shut off engine and started again and problem went away for about five minutes and then came back. just wondering if anyone had this problem or what it might be. i am gonna take sled to dealer to look at it.
 

OnlyPolaris

Active VIP Member
Joined
Apr 28, 2008
Messages
1,964
Reaction score
524
Location
Lloydminster, AB
most likely running bad gas or gas with ethanol in it. Make sure your wires are plugged or un plugged according to the type of fuel your running. also make sure your running premuim.
 

71250ford

Member
Joined
Dec 14, 2008
Messages
19
Reaction score
0
Location
okotoks, alberta
thanks. yah i always run premium in it and i am pretty sure the fuel that day was non ethonal added gas. but there might have been a problem with moisture in the fuel because a day before my sled was in the garage with the heater on and that same night i loaded it up on the sled deck. i have not touched the wires on the sled for fuel yet, so it is set up whatever is stock. but i am pretty sure when i gassed up at petro-canada on the number one highway just out of calgary, there was nothing stated on the pump that their fuel contained ethanol.
 

Metalfusion

Active VIP Member
Joined
Dec 3, 2008
Messages
299
Reaction score
8
Location
Leduc Alberta
I notice you said on the trial out when this happened. Was the first time on the trail in? The 09' and 10' 800 had a lean spot in the midrange. Maybe this culd be the issue?
 

71250ford

Member
Joined
Dec 14, 2008
Messages
19
Reaction score
0
Location
okotoks, alberta
yah might be the problem, but why would the light not stay on? my first time on break in nothing came up. and everytime after shutting down and restarting the light would not come on right away.
 

Dynacorkle

Active member
Joined
Nov 24, 2010
Messages
85
Reaction score
0
Location
Central Alberta
Have you done the recent update's from Polaris yet? My buddies 2010 Assault was doin that, and by the end of the day the machine would start shutting itself down. He'd could get maybe a kilometre and it would shut down again. Long trip out. I thought it might be a stator. It ended up being the regulator, they have an update to replace it and relocate it under warranty. Also i think there was some other ECM update's.:beer:
 

71250ford

Member
Joined
Dec 14, 2008
Messages
19
Reaction score
0
Location
okotoks, alberta
thanks, yah i will get the dealer to have a look at it. i heard some guys having problems with the voltage regulator and if there is a new update out then i will see if they can do it. i thought it had all the updates on it already because i bought it in june, but maybe not.
 

capt. crunch

Active VIP Member
Joined
Nov 22, 2010
Messages
418
Reaction score
472
Location
revelstoke
No problems with mine! 255 miles
I believe there was an August reflash though,which you wouldn't have if you bought it in june.
 

timbo

Active VIP Member
Joined
Dec 18, 2006
Messages
1,088
Reaction score
386
Location
edmonton
sound like mid range stumble,running about 5500-6500rpm.light comes on when engine sense's detonation if held there long enough computer will go to safe mode.have dealer pull all codes out and have them reset TPS adjustment and install latest reflash. my 09 dragon never ran right till they changed lower injector harness and the stator.I think it was the stator all along,never had any problems with the regulator,thats about the only thing they never changed.
good luck
 

71250ford

Member
Joined
Dec 14, 2008
Messages
19
Reaction score
0
Location
okotoks, alberta
thanks for all the replies. i talked to the dealer and they told me a problem like this sounds like bad fuel. low octane. the also told me even with running a 91 octane you should have your fuel change wires unplugged and if you ever have your engine detonating because of bad fuel unplugged them wires first. and just wondering what is the deal with all these re-flashes. what does a reflash actually do?
 

timbo

Active VIP Member
Joined
Dec 18, 2006
Messages
1,088
Reaction score
386
Location
edmonton
Reflash changes the fuel mapping,last one added more fuel to mid range.Mine was bogging bad in mid range,once they got my tps set proper it runs fine.I have the second last one,no need for last one.My buddy has 800 shift and he has the second last one.I think no two are alike,there settings are all over the place.
 

hayastusa

Active VIP Member
Joined
Nov 7, 2006
Messages
185
Reaction score
12
Location
Lloydminster
. the also told me even with running a 91 octane you should have your fuel change wires unplugged.
My dealer told me plugged for premium; unplugged for low grade, ethanol blended or suspect fuel. The manual says the same. This is my first Polaris, you guys gotta quit dickin' me around with this wire thing:confused:
 

timbo

Active VIP Member
Joined
Dec 18, 2006
Messages
1,088
Reaction score
386
Location
edmonton
My dealer told me plugged for premium; unplugged for low grade, ethanol blended or suspect fuel. The manual says the same. This is my first Polaris, you guys gotta quit dickin' me around with this wire thing:confused:

You are 100% correct. :beer:
 

bensen

Active member
Joined
Jan 23, 2010
Messages
77
Reaction score
16
Location
saskatchewan
There's a good chance it's going to go boom shortly,just getting mine rebuilt today. Not good.
 

71250ford

Member
Joined
Dec 14, 2008
Messages
19
Reaction score
0
Location
okotoks, alberta
oh man, why did your's blow up? rebuild so soon. yah i was told to unplugged the wires for suspect bad fuel or not high enough octane. also was told the commander 5 fuel programmer does alot of good for these sleds
 

t-bomb

Active member
Joined
Nov 28, 2009
Messages
95
Reaction score
2
Location
calgary
got a 2010 assualt (stock) and reflash Late feb 2010 when I installed new track (stock one junk). I plug my wire in always and run shell gold ALWAYS.

FYI I have an ethonol tester from briggs and straton and I didn't find any in Shell or Perto can premiums in Sicamous.

I will say since the last reflash I have lost a few rpm up top. 8050 vs. 8200.

usually not looking down could have been that one pull up the hill because the guys were asking
 

Riverjet

Active VIP Member
Joined
Dec 24, 2008
Messages
1,703
Reaction score
1,388
Location
Prince George
oh man, why did your's blow up? rebuild so soon. yah i was told to unplugged the wires for suspect bad fuel or not high enough octane. also was told the commander 5 fuel programmer does alot of good for these sleds

What does the owners manual state the required octane is for this sled?

It does nothing but waste your money using anything higher than what the owners manual says unless you have increased the compression.

The wire plugged in or unplugged is only to compensate for ethanol or non ethanol fuel, not the octane rating.
 

OnlyPolaris

Active VIP Member
Joined
Apr 28, 2008
Messages
1,964
Reaction score
524
Location
Lloydminster, AB
should run minimum 91 octane. I have always run wires plugged in, shell v power with some octane boost and a bottle of gas line antifreeze with water remover. I have never, never had a problem with any bogging or detonating. Thats running the original 2010 flash on my old dragon and then the february flash on my current rmk.
 
Top Bottom