starting to tune the rt

[1100]

Just bought a new boony box. Will give you update tomorrow when I install

 

[magnet]

Hmm found instructions online and it says just plug into factory harness wtf somebody who has installed one of these please update us blind people lol

 

[magnet]

So started to read the instructions and that plug has nothing to do with the factory harness it is for a backup battery
Try the link I pasted should take you to the PDF not sure if I did it right with the phone or not

 

[hdkawi]

i have the same instructions the battery is to tune the box with the sled not running

 

[hdkawi]

so niether of us is officially blind?

what is your serial # the two i looked at 000018 000026
maybe the early 05 didn't have this plug

 

[1100]

So this 10 pin connector is for the tps wire installation that you need hooked up to control nitrous. There seems to be a 10 pin on the 07 sleds. There is a 12 pin wire for the earlier kits like yours I beleave. There is a separate detailed set of instructions for how to install this. I will not be doing this step as there is no reason for me to do this with my turbo application.

 

[1100]

 

[1100]

Re: starting to tune the RTs

 

[1100]

Re: starting to tune the RTs

Sorry about sideways pictures took off phone can't seem to flip them.

 

[hdkawi]

Re: starting to tune the RTs

do u have a pic where u conect your 10 pin boondocker
is there a adapter from 10 pin to 12 pin?

 

[hdkawi]

Re: starting to tune the RTs

wow i must of been missing a page of the manual found this on line
you ty into the harness right at the injector one female plug and one male

 

[hdkawi]

Re: starting to tune the RTs

don't loose the clip lol
i had to drain the colant from the plug under the belly pan then remove the coolant bottle to
change the injector on the mag side

 

[1100]

Re: starting to tune the RTs

Lol I thought you already had that done. Box is simple gets power off injectors. A ground and away you go. Thought you were having nitrous trouble. I don't even really understand them directions.

 

[hdkawi]

Re: starting to tune the RTs

got it running and installed a set of koso egts now i have to learn how to tune the box once i get that then i will start on the nitrous the fun now lol

 

[popcorn popper]

Re: starting to tune the RTs

Anyone needing a booney box I have one new in box. 300 bucks and also a pipe for another 300. New in box ceramic coated.

 

[hdkawi]

Re: starting to tune the RTs

Anyone needing a booney box I have one new in box. 300 bucks and also a pipe for another 300. New in box ceramic coated.

thats a good deal where were you three weeks ago lol

 

[hdkawi]

drilled egt 30mm from y pipe that will end up being 100 mm from skirt, i had a spare mono block to
measure with

 

[hdkawi]

got it finished:d anyone want to share there boonkocker settings? i know that every machine will very and you need to
find rich first these rt's don't like lean one bit

 

[magnet]

Looks good. Your egts will read low though I think because of probe location looks a little close to the head IMO but once you get a baseline who cares.
I've been trying to get numbers too lol. I think they are secrets only given out to the free masons.

 

[magnet]

thats a good deal where were you three weeks ago lol

Chit I didn't even pay that for pipes and the box. Just sayin
Thanks again for the ripping deal secret Santa