Search results

Hello, i,m a long time member of the board, and came to Sun Peaks on holiday with my family from Victoria. I went out on a trail ride from the resort and followed the clubs trail network. The snow is very deep, with no base. I end up burning up two belts and had to leave the sled and walk out...

I have an 03 S/C RX1 with MPI Cromemoly skid parts extended to 162X16. The front is stock A-arms with Works shocks and Simon's Gen 2 powders skis. The sway bar is long gone and I have lightened up everything that can be taken off. The sled is a beast to turn at slow speeds and a handful on the...

As part of my pre-season preps I noticed the bearing behind the secondary clutch is rusty and getting loose. There are no Yamaha snowmobile dealers on the island but my local motorcycle dealer will bring it in if I can find the part number for the replacement bearing. I have the CD with the...

Snow starting to build up at Jutland just north of Comox! Won't be long now.

I run a knock box on my SC RX1. If it records knock it must have the power interrupted to reset the display. I want to mount a momentary switch on the bars, but there is a catch... It must be normally closed and momentary open. This is opposite most kill switches which complete a circuit when...

I had a large get off down a rocky creek bed today and wiped out the left side front suspension. Looks like both control arms, maybe the spindle and the simmon's powder II is bent into a "V". I don't think it took out the bulkhead but I'm too tired to look tonight. I need some help on...

2003 RX1 VIN Location I purchased a 2003 RX1 and want to register it. They came out to confirm the the VIN when I went in to complete the registration and transfer. The sticker on the tunnel is worn and some of the number are not visable. Is there a second location for the VIN? They won't...

Finished the full rebuild in my 03 VE, hope the improved crank from CT Tech (Japan style bearing) lives up to the hype of being significantly stronger. While I was in there had the case line bored as well, new pistons/rings, one cyl, wrist pin bearing. I have an older reed cage from Boyseen...

Hi guys Was looking for a little advice. I have a 03 800 Vertical Escape with PERC and was looking for the correct method of setting chain case tension. I hade to much slack last year and it had a good “clunk” going from reverse to forward or when coming back on to power after coasting down a...