Search results

Anyone running one with a few KM's on it yet? Likes, dislikes. Comparisons...

Alright fella's I pulled the trigger on a 2019 CCLB. Single wheel alumaduty, gonna pick out a new 8ft deck in the next couple weeks, in my 11 dodge (6'4" box, 7ft deck) I had it bolted through the box with 4x6" plates from the bottom in all 4 corners then turn buckles in the front two corners as...

Anyone running the zrp z motion triangles? https://www.zollingerracingproducts.com/ski-doo/5t677zy2ew74u3fntu39t1coei5576

Anyone put these on their factory KYB shocks? Good, bad, ugly?

What are you guys running for a wear ring? Bronze, Brass or fug it and just go stainless on stainless?

Any one in Edmonton or AB have any? They are on back order from skinz and their western Canada distributor! Also anyone that has ran them consider getting a set machined out of stainless for longer life? TIA.

Anyone has a set of non ras2 spindles they are willing to part with? either a set or just a RH one will do, not fussy on colour as long it's not pink.

Anyone have the t-motion locked out on their xm's? If so what did you use? skinz has the washers that limit it but I don't wanna be changing those out every 300 miles.

What are some of the phone numbers everyone has stored in their sat phone? post em up, was thinking search and rescue for the area your riding and a chopper company or two if possible.

Anyone know where to get this stuff in or around the edmonton area, looking for 3 sheets to redo my deck also heard of the infiny board product that mline uses.

Johnson 8hp outboard kicker, very clean, runs great just dont use it, always fired up periodicly to rabbit ears to keep fresh fuel in it. Kijiji AD# 1102052246 Located in cold lake but travel into edmonton area often.

Bondi*. Anyone running one on their xm? Worth the cash?

Anyone do the 156 3" swap on their 154?

Anyone have a 156 16 wide 3" they wanna part with shoot me a pm

whats everyone doin to their xm's over the summer months?

Just wondering if anyone has put different bars on their 12 or 13, I have the RSI kit for the left side block, two small switches for kill and a RSI throttle block. Just a little nervous about wiring and such. Any input?

i picked up a vent kit from XXX mod rods just wondering what everone else is doin with the duct on the clutch side are ye'all leavin em out or re-installing them with the vent kit. Thanks

Whats everyone do with the small vent on the lower RH Shock tower... its taking in snow pretty bad and froze up my reverse. just donno if i want to block it. thanks.

Has anyone wired in a different tach on their nytro... havin a hard time seeing the stock one.

Ok so being that im still in my teenage bush party and such years I had this great idea that we tested last weekend and it worked. So i have ama on my truck and we drive out to the bush party get pretty tourqued up. No one that i trust is sober enough to drive my baby so i call ama and tell them...