Search results

All the skidoo gurus out there, what symptoms would you have if one of the internal crank seals in the middle were to fail?

2017 summit looking for top end torque specs. If anyone can help me out I did a bunch of searching can’t find anything I’m sure I’m just missing it this can’t be the first time being brought up.. lol Also what should compression be I tested it last week 2 different gauges showed 104 psi both...

Posting for a friend stolen from his driveway.

Wondering if anyone has come across this, over the last few weeks my exhaust brake has been coming on on it's own and stays on until I either tap the brake or sometimes it's so bad I have to pull right over and shut the truck off and restart the truck, and then it's fine this is with or without...

Ok i have the above sled in my garage and it has me stumped. The owner said he just bought it rode it for about half hour then just quit. It starts up after a while of sitting but quits shortly after like 5-15 sec. and is a bugger to even fire up but again just quits right away. These are the...

Posted in Lost and Found just throwing it here as well. Tell me what they look like (keys and lanyard) and i will send them off to you.

Tell me what they look like (keys and lanyard) and i will send them off to you. I will also post in other threads.

Doing a top end in an rev and using spx pistons duel ring going to install them pulled them from the box and they are both labeled standard but one has a 4F stamped in as well and the other says 3E is there a difference between the 2? Never ran into this before can't find anything on line.

Has anone ran into these symptoms before. Near the end of the season my tether was acting up it would intermittently not kill the engine as well as the roll over valve wouldn't close. If I didn't have the tether hooked up the sled would still start. It has the relay set up on it and it...

Picked up a set of boards just wondering what u guys or gals did for the rear tunnel. It is stock tunnel still and the instructions say when cutting off the boards not go past a certain point at the drop brackets leaving the back portion. I'm just wondering how that will look in the end. Has...

This one has got me baffled. Purchased on line manual. 2000 600 grizzly was burning oil bad (smoking). Started and ran fine. Tore down, cylinder glazed still well within spec. Honed cylinder stayed stock size piston, ring gap within spec. Noticed timing chain was stretched r&r as well. No...

Just a shot in the dark, went up Renshaw today i believe i droped my Blackberry phone in front of the cabin. It was turned off at the time if turned on it has all my return info on the front screen. Anyone that was up there today nows the snow was sick so again just a shot in the dark it was...

Just throwing this out there noticed today at Princess Auto front are $80 off ($119) and rear are $60 off ($90) if anyone is looking. Can't beat that..

Last ride of the year ended nicely with my sled landing in it's lid and smashing the cluster to sh!t. My question is about the milage, can i pick up used cluster and it show the same milage when pluged in? or can i get a used one have it reprogramed?? Is the milage info stored in the computer?

Just throwing out a hail mary here. I got a 2004 outty 400 xt the 4x4 actuator crapped out and i removed it and found the motor still functioning properly but one of the gear reduction gears has 2 stripped teeth cause the 4x4 not to fully in gauge. Rather than spending $700 on a new one just...

Just throwing out a hail mary here. I got a 2004 outty 400 xt the 4x4 actuator crapped out and i removed it and found the motor still functioning properly but one of the gear reduction gears has 2 stripped teeth cause the 4x4 not to fully in gauge. Rather than spending $700 on a new one just...

Well lets start this off with a bang. My cuz sent me this about 3pm. Still coming down, this from up Atlas.

08 700 I've Checked the linkage and all is good. Moves forward fine in low and high. I have searched the net and found that it is most likely the bushing on the reverse idle gear. Couldn't find anything on here in regards to this through search function. I'm am just wondering if anyone had...

Currently snow fall at a good rate just in time for the weekend, it going to be good out back with a little fresh. We were going out again today but we are going to see if this dies off abit. These are out the front window at the bottem of the ski hill in Blairmore.

I have read somewhere that a arctic cat skid is a direct replacement for a yamaha and are signficantly lighter? Does anyone know what year to be looking for? 162" 06 apex? There are a couple on kijiji but don't know if will fit for sure. Or if anyone has any other ideas without spending a...