Recent content by Powerstroke2000

Heading down this way from western Canada in mid May, and I've been trying to find just how much riding (below snow level) might be available from mid May on? We'll initially be heading to the Moab region to start our riding, and then we're open to ride other regions, so hopefully this one...

I just happened to notice you mention that you did some quadding in the Crowsnest Pass region. My wife and I, and brother and sister in law have a trip planned for that area next summer, but have no idea where to start? I thought perhaps you could give us some tips on where to camp, where...

Thanks Mike! Since I've never been to these areas though, I'll have to check out my maps to see where they are. Not sure if "trails" will show up either, but I'll give it a try. Boy, if someone from the Crowsnest area where to write a book on the area, explaining many of the trails and...

We have insurance, but here in B.C. we aren't registered (quads) so is that a problem if riding in Alberta? It's actually tough finding quality information on the Crowsnest Pass for camping/riding unfortunately. I've put out a few e-mails, hoping for some info on the subject personally...

We have 3 couples intending on visiting the Crowsnest Pass region (3 motorhomes in August) and we are looking for information on where one can "camp" and perhaps have the abilty to ride from the comfort of our motorhomes? We've heard good things about the Crowsnest region for ATV riding, so we...

Sorry... no delete function.

Thanks Gunny for those links. Upon doing my own research I eventually found a Purolator phone number I could call..which I did. I was told the ML16817 is the correct oil filter to fit the 700 Grizzly. The PL-14610 is the one that fits the Grizzly 660. Both are a tad longer than the OEM...

Is there a way of doing this without altering the look of the quad? Holes in the side panels I can't see as being a hack job (by myself anyway) and I like the clean lines of the Grizzly, thus don't want to hack up the quad without looking for alternate ways to remedy this issue. There again, I...

Thanks, but I'm not quite sure where you would drill these holes? You don't mean the outter plastic do you, as that would take away from the look of the machine wouldn't it? Does anyone have a theory as to why the steam seems to make it into the air inlet, as I don't hear this happening with...

I'm running ITP XTR's and no complaints here. Talked to a guy who had over 5K on his, and they where getting down on tread but still doing the job! PSD2000

Anyone have some links they could share, that help to eliminate the "sputtering" problem with the 660 Grizzlies when traveling through water? I've heard it could be "steam" but can't figure out how the heck steam could get to where the intake is? I've also heard that it could be the...

You might want to head up to Sumas, then towards Chilliwack Lake to an area known as Tamahi (right after the bridge, where you'll see a setup for kayakers). There is a campsite there as well, but an old forest service road heads up into an area with alot of spur roads that are fun for riding...

My wife and I ride Yamaha Grizzly 660's, and we're enjoying the sport greatly! Hope to learn alot from you folks over the years! Thanks. Dale