Recent content by JustBoostIt

Looking good Chris. I'm thinking I might just powdercoat all the intakes as black works with anything and then it's done. Flashing SW and KC ecus like mad, the reviews are great. Can't wait for yours, I'll add it to my All Go Customs FB page when you're done.

I have been the Evo distributor for Canada since before they were a retail company. Was involved in much of the r&d of their bolt on parts and turbo kits, and built many 1100t monsters when I owned White Knuckle, including three 300+ hp ones of my own. I stock pretty much all 1100t Evo parts in...

On the hill performance always speaks for itself. I haven't had anyone that I re-flashed over another brand, or replaced a piggyback for, that had negative comments about Evo's performance. 100% people will post bad experiences, try to find an Evo one. Most common thing i hear is how the Evo hp...

WKM is the Evolution Powersports distributor for Western Canada, and Evo is the only company that builds and tunes mountain specific 1100 turbo kits. To make over 250hp consistently at elevation requires a bigger turbo among other things. We have sold over 80 m1100 turbo kits and installed a lot...

The Evolution Powersports kit I run is 275 on 100 with no shim. I reflashed my ecu with the new Evo Hi Compression turbo flash for raised rev limit and timing which makes it possible to run another couple pounds still using the 100 octane. Should be around another 10-15hp with a little rpm and...

Have used the 38/46 helix since 1100s came out. Tried a Shockwave back then and didn't like it. A progressive helix in our elevations works very well.

Sometimes you can get away with taking the actuator apart and rotating the circle gear to a new contact spot and it will work fine too. They can get much play when they get worn and hang up.

Sold about 150 of them in the last 4 years being the distributor for Western Canada. With increased boost with flashes etc the stock $1.99 one has trouble holding the extra pressure. The Evo one is a nice riding improvement over stock because of better control and the ability to hold boost...

Most dealers have had them for a couple weeks...

Are you still looking for one? If so shoot me an email to gene@wkms.ca

Not sure why you wouldn't try to find one at one of many Cat dealers in AB or BC before trying Evo, or even me the Canadian distributor for Evo.....or maybe you have, but I'm sure there are some out there. I know we had stock until maybe last week. Evo's are the same as the Jacobson ones we sell...

Evo's Viper kit has altitude compensating but they are the only one I know that does.

Did you follow the instructions on Evo's website for the install? We get them to fit very well but after 50 or 60 you get better I guess. Did you trim off the ends that go onto the factory vents? If not they make the hood push up. Some require more trimming than others as ever hood sits just a...

Will do. I have a fair bit of interest in this performance kit so I will post results.

Sold about 150 of those with the intake elbow. Lots of easy Evo bolt ons for the 1100. If you have any questions you can shoot me an email to gene@wkms.ca. I am the Evo distributor for Western Canada and stock it in house. Just mention you are the guy from S&M if you do.