yamaha1
Member
hi i was wondering with the power commander 5 how do you get the maps because the sight was not working for me and do you have to put a map on it with the autotune hooked up
I installed a PC 5 on the weekend. I am not sold on these at all. For two strokes anyways, just for the simple fact that in order to make any adjustments to the fuel mapping at all you have to hook it up to a laptop. Who carries a laptop with them on them on the mtn. The one i installed with slp's mapping for there set-up worked good, but if you do any other mods then you may have to start messin around with maps. Slp told me that the auto tune isn't the answer to it all either, so we will see how it works as i'm going to do more playin with these.
I installed a PC 5 on the weekend. I am not sold on these at all. For two strokes anyways, just for the simple fact that in order to make any adjustments to the fuel mapping at all you have to hook it up to a laptop. Who carries a laptop with them on them on the mtn. The one i installed with slp's mapping for there set-up worked good, but if you do any other mods then you may have to start messin around with maps. Slp told me that the auto tune isn't the answer to it all either, so we will see how it works as i'm going to do more playin with these.
Not sure what you need to know so I'll just ramble a bit. Dynojet does not have sled maps. you have to make your own or load someone elses. I am assuming you have autotune by your post. The only map you need when using the autotune is the target AFR. The autotune will create a trim map for you based off the target AFR that you will have to accept in order to have a running map for your sled. While the autotune is enabled it will apply the trims instantly but you need to build a running map from that. After you have a map made you take off the autotune.
Read all the instructions and check out the dynojet how to vids.
Creating the target AFR map is the real trick