byronkentgraham
Active VIP Member
So I had to replace my taillights on my old trailer(cattle broke them off).
Coming out of the trailer there are 2 green wires for each light(one is a ground and the other i don't know) and a red one(brake and signal lights.)
On the old tail lights the two green wires were merged into one wire, then split back into two right before the went into the plastic housing. The red wire went straight in.
The new tail lights are different wiring and won't work if the non-ground green wire is connected. Both lights will flash when signalling if green is at all connected.
Old lights worked perfectly.
Anyone had anything like this?
Coming out of the trailer there are 2 green wires for each light(one is a ground and the other i don't know) and a red one(brake and signal lights.)
On the old tail lights the two green wires were merged into one wire, then split back into two right before the went into the plastic housing. The red wire went straight in.
The new tail lights are different wiring and won't work if the non-ground green wire is connected. Both lights will flash when signalling if green is at all connected.
Old lights worked perfectly.
Anyone had anything like this?