ippielb
Active VIP Member
- Joined
- Mar 4, 2011
- Messages
- 1,917
- Reaction score
- 3,315
- Location
- SE Saskatchewan
- Website
- www.youtube.com
I have an M6 motor swapped into my 06' SnoPro chassis. Fired it up tonight for the first time. Ran into a weird problem. It idles extremely fast(no gauge but i will get my laser rpm going tomorrow), and theres a large knock from the PTO side. I hope it's not a crank seal because it was a PAIN to get that motor in there with all the braces and supports from the race chassis.
There's a lot of plugs that i am not using. There's a two prong both female end, i assume plugs into the Diamond Drive? It's by the servo motor plug.
There's a bunch of plugs that look like hand warmer plugs i am not using. 6 wire plug yellow and green wires, then another 6 wire plug, yellow green and brown. I assume one is for hand warmer control switch that i do not have on the handlebars, and the other is for the handwarmers to plug into, which i don't have either.
Anyone have suggestions on what to look for? I'm stumped. I'll get a video tomorrow.
There's a lot of plugs that i am not using. There's a two prong both female end, i assume plugs into the Diamond Drive? It's by the servo motor plug.
There's a bunch of plugs that look like hand warmer plugs i am not using. 6 wire plug yellow and green wires, then another 6 wire plug, yellow green and brown. I assume one is for hand warmer control switch that i do not have on the handlebars, and the other is for the handwarmers to plug into, which i don't have either.
Anyone have suggestions on what to look for? I'm stumped. I'll get a video tomorrow.