clutch weights for pro rmk

[dreinking]

What weights are you guys running for 8-10000 feet. I was told to run 58 gram ones.

 

[RUDY]

manual shows 10-60 and u will have to change the secondary spring to

BLK/PUR160-2407043363​ ​

 

[dreinking]

Ok I was just wondering because a friend of mine ran the 58s and said it held better rpm curious to see if anyone else tried it.

 

[HMI]

Hello, I am putting on and slp pipe and can. I have changed my weights and spring in my primary but I can't get my secondary apart. What am I doing wrong?

 

[Stg2Suby]

Hello, I am putting on and slp pipe and can. I have changed my weights and spring in my primary but I can't get my secondary apart. What am I doing wrong?

Pull the helix 4 bolts


You need to get this snap ring off the groove in the shaft but the spring is compressed underneath


Homemade tool with threaded rod, washers, etc or buy the special tool to press the spring down a bit, remove snap ring then release spring tension to change it out

 

[Stg2Suby]

when put it back together you need to align the "skip tooth" on the retainer with the shaft splines.

white mark is the skip tooth, take a felt pen and make vertical line up the shaft to mark the location (can't see it when assembling)


press the retainer back down aligning the X with the skip tooth