Hey guys, does anyone know who does work on the boost-it's anymore?
I expect the turbo is fine but for some reason the sled started completely losing power and struggling to get to 5500rpm, even when coming down the trail to boulder parking lot. Not sure what's going on but when it started losing power I flipped in new plugs because it felt like I was only running on one cylinder but no change. When trying to pull back out the trail the power loss was somewhat intermittent in that the turbo kicked in and pulled up a climb on two occasions on the way out, after I failed to make the climb due to the power loss and had to roll it over to take another run. Weird but it seemed like rolling it over caused it to work again both times for those two separate climbs out. Also pumping the throttle seemed to help get the boost up, but again, that was only after the roll over. When I got home I checked turbo oil and it was quite low, so I filled it up but still no change. Can't get it above 5500 rpm. Both cylinders are 100lbs compression each side, and new plugs in place.
would appreciate some assistance or helpful advice. Thanks in advance for any responses.
also, does anyone have a PDF of the XIC manual? Bought the sled second hand and didn't come with it. Thanks!
I expect the turbo is fine but for some reason the sled started completely losing power and struggling to get to 5500rpm, even when coming down the trail to boulder parking lot. Not sure what's going on but when it started losing power I flipped in new plugs because it felt like I was only running on one cylinder but no change. When trying to pull back out the trail the power loss was somewhat intermittent in that the turbo kicked in and pulled up a climb on two occasions on the way out, after I failed to make the climb due to the power loss and had to roll it over to take another run. Weird but it seemed like rolling it over caused it to work again both times for those two separate climbs out. Also pumping the throttle seemed to help get the boost up, but again, that was only after the roll over. When I got home I checked turbo oil and it was quite low, so I filled it up but still no change. Can't get it above 5500 rpm. Both cylinders are 100lbs compression each side, and new plugs in place.
would appreciate some assistance or helpful advice. Thanks in advance for any responses.
also, does anyone have a PDF of the XIC manual? Bought the sled second hand and didn't come with it. Thanks!
Last edited: