arcdoo
Active member
1996 600 XLT will not run on PTO cylinder has spark 130 PSI and choke cable is fine and fuel .....thanks
1996 xlt 600
- Thread starter arcdoo
- Start date
007sevens
Active VIP Member
reeds?
- Thread starter
- #3
arcdoo
Active member
No reeds
Poo time
Active member
I had one that was doing that and part of the lower piston had fell apart and went out the exhaust. Bad crank seal is what caused it.
- Thread starter
- #5
arcdoo
Active member
That's what I was thinking...thanks
kenvb
Active VIP Member
crank seal ? with it running, gently spray brake clean inbetween clutch and motor.if it picks up. crank seal is gone. common problem on those.
cattechsummitrider
Active VIP Member
it can also be crank is twisted, Have seen alot of the triples twist on a crank pin and go out of phase
Similar threads
