Search results

My sister works for capri insurance and the 48.00 regi fee is not mandatory until June or July she told me. It is your choice to do it now.

Thank you. I didnt realize they were converting ac to dc with it, since its called a booster I thought it might have been increasing the voltage. Well ill call boondocker tomorrow and see how much one will be.

Wondering what this device really dose and whats inside it? Reason I ask Is I got an intercooler but it did not come with the booster. Can a guy make his own? I have tried to google it but cant find anything out Thanks

I have same issue except my break light wont work on the dash or the gauge. Also the last ride out my master cyl sucked the rubber seal down from the cap. I just checked my tps and its set to spec. I will check for moisture but its been sitting drying for almost a week now

7000 miles on a set and there still good. Not using them anymore as there from my old rev but worth every penny

Okay I booked it in at doc johns in kelowna fir this thursday

sorry guys i forgot about this post. there were tracks all around the sled. but there was no track/trench behind the sled. it was on a hillside full of dead trees and there was no trail behind the sled. it looked as if they drug the sled down the hill and pulled it back wards to where it was as...

i am powering the ecu using a 12v battery pluged into the ecu power plug above the primary clutch. (orange and brown wires) then i back probed the red/white wire on the lower ecu plug and it reads 5.4 volts the blue wire on the same ecu plug in number 7 is reading 0.81 sorry for the doubt but...

im testing my tps right now and i am getting 5.4volts where its stated 4.99-5.10 volts. im using a snap-on digital multimeter show it should be a good reading. how would i adjust this back to 4.99-5.1 volts or what is causing this reading? also before i closed the throttle bodies and checked the...

Call mongoose machine in vancouver. Get them to rebuilt the crank in house. Or else they will sell you a cvtech junk. I had my cyl done by them and got the fix kit from them as well I beleive I paid 525.00 for fix kit and 480 for the replate. Also topend gasket kit was 50.00

Call jim at redline recreation I know he has one for the 03-06 rev that should work since the the old engine not r engine

Sold thanks snow and mud

I have one day sled rental for sale. The buisness is sun and snow adventures based out of enderby bc. I won this rental at our local hills bingo rally. Im only selling it to raise a little extra cash to repair my sled. It has a value of 300.00 plus taxes. Fuel is at your expense. He will...

guys i would not risk this... i made my own filter using the napa gold 3300 filter and my engine just went down. mag side shows lack of fuel. they say the stock filter is a 10 micron and so is the napa filter but its either the filter or mag side seal or bad fuel pump i guess?

Well it was not an oil issue. It just got hot and started to seize. Ill post picture tomorrow but the cyl has to be replated. I can only think it ran lean for some reason? Crank seal or fuel injector failing or plugged maybe ? I have been told by mainjet there using m8 pistons in there pros...

yes sled has been running great as it was set up. looks like lack of oil to me though? once on top the egts dont seem to go above 1280 its just a certain spot in the throttle it will climb high. my grampa's 13 is the same way. i will take photo's soon i just got the top end off and it looks like...

today we went to go for a ride and it went down on mag side. water temp was 122 before we left the trucks, it made it 10k down the trail. egts were in high 12's-low 13's highest i seen was 1325. they dropped to 11xx then one quick short pull of throttle and it shut off.. tried to pull it over...

Hey guys just wanted to post my numbers the sled has been set at. These are all psi numbers just so you know. 4300 08 10 00 5100 08 11 13 8200 25 34 34 8500 25 34 37 When I bought the sled I had doc john in kelowna look it over, he has built a lot of these turbos and...

well i found my issue, the three wires coming out of the clip to the tps sensor had previously been repaired and now this time the red wire was cut and the blue wire was rubbed threw. my question now is would this have caused damage to any other electrical device? once i repair the wires dose...

sorry to sound stupid but what will i want to see on the bd box? or what will i see that will tell me i have an issue? i tried to google it but cant find a test using the boondocker box