Recent content by wants snow

Thanks for the info guys. Stupid what I found but got it in my head it was a clutch noise. Nope. Two things I found. Rivits holding the power valve servo motor are loose and rattle at idle. In that area so I could see it. How ever the real loud noise was actually the front shock on rear skid...

Hey guys this post is from last year. Same noise still there. Going to open up and look again. Seems like my set screws always come loose with these mds weights. Why would this be? Could this be my noise? I do always tighten them and use red loctite and give proper set time and temp. Friend of...

Re: M8 to Pro 800 or Doo Opposite. Completely 100% happy with my M8. Looking for new sled and not brand specific in any way. have rode the new chassis 13 and 14. personally I was expecting the new chassis to be totally different and blow me away. It is a good sled also don't get me wrong but I...

Re: M8 to Pro 800 or Doo Sorry guys this was suppose to be in the pro section. oops. Doo guys feel free to chime in also. Anyone switched and very happy..

M8 to Pro 800 or Doo Currently riding a 2010 M8 sp. rode a 14 pro 800 155 for weekend in mountains and was surprised. liked how easy sled was to go where u want to go. I am a lighter 140lbs with out gear. I was worried about feeling some lack of power but felt other things were lacking...

question on my 2010 m8 sp. with sled idle and running primary clutch seems to be making noise, almost like something would be loose. have about 1000km on it. while driving at higher speeds or high rpm sounds fine and runs great but when slowing down to stop or just idling sled can hear it making...

got a 2010 m8 sp, mbrp can on it never had any problems with it. looks real good and i like the sound as well. have 38/44 helix in secondary. i am 170 with gear on i dont know if it would work as well with a heavier rider or if the 44 would be to steep. running mds weights, really like them seem...

yes bolt pattern is different. my bad.

Quick question, will a 2008 m800 y pipe work on a 2010 m800 ho? Got a new slp y pipe from a 2008 m800 and was going to put on my 2010 m8 but could not find any info if they are interchangeable? anyone know?

I have a 2010 m8 sp. Has been running with no problems. Going to Valemount this weekend and last time out i changed belts because other one was getting old. Was riding in snowmobile rally doubleing and sled had a hard time pulling rpm. was only coming to 7700. i have mds weights. set to run at...

Just installed Boyesen rage cages on my 2010 m8 sp. Nice fit and finish fairly easy install. coolant hoses were the hardest part. Did notice a difference for sure on throttle response. nice and crisp everywhere even at higher rpm. I did not expect to notice anything other then bottem end. Was...

I have heard they fit and work well. Have also heard 2009 M8 reeds are better than the 2010 2011 ones. Not sure i have never had a sled with aftermarket reeds so i wanted to try a set for myself.

Got a 2010 m8 snow pro starting to get a odd low end bog sometimes when hitting throttle. If i hold the throttle open or almost open when bog does happen it feels like it will bog right out and stall, but i have not tried. Reading past posts and have had a few buddies with 2010 and 2011 800s I...

will agree, happened to my cat also. check for secondary small bolts starting to break behind secondary clutch.