Just bought a 2011 RZR 800s. Anyone hauled one on a sled deck on a shortbox. By measurements it would be very tight for length on a 7' deck. Have a bumper pull holiday trailer and still want to haul my dirt bike as well.
I have used hoses clamps before to keep the rings in the grooves. Just snug them up a bit until the ring is seated properly, then push the cylinder down onto the clamp, which will keep the ring compressed until it's in the cylinder.
Just installed a new 2.6 PC 85duro 153 on my 11M8. Anyone had to adjust clutching with this upgrade?
153" x 2.25 PC for sale, 80duro, in good shape, 300$ Message me if interested.
I'm running the Skinz super-q on my 2011 M8 and runs flawless. Has a nice tone but not near a loud as an MBRP. Running stock y-pipe and pipe. I also have been considering the MDS weights or RK Tek secondary. Clutching is fine @ lower elevations, but I have found peak RPM to drop off at elevation...
There is a kit from Artic Cat that provides guards to go around the hand warmer switches and kill switch. They just glue on and are pretty cheap. Makes it way harder to accidently hit switches while riding.
Was recently riding out in revy. Rode the whole day without any problems. About 330 my sled just crapped out, out of the blue. Was only running on one cylinder and then quit all together. Unplugged my boondocker controller and it fired up first pull. WTF. Running an 07M8 with y-pipe, single...