Recent content by rwjk0

No we never did

Mostly Sunny was a nice touch too

Renshaw today. No base at all so plenty of carnage on the hill today. Turbos got a work out and tanks were empty by 2pm. Trail surprising held up great with minimal whoops on the way down. Mind you we came down early due to running on fumes.

Agreed! I've also often wondered, we all wear our $1000.00 Avy packs, but I'm not all that sure that while being chased down the mountain by an Avy and trying to maneuver my sled out of danger. Would I even remember to grab the ripcord or would I be too focused on trying to steer clear of the...

I think it's a great idea, can you buy one before the 19th?

Cross your fingers that you didn't buy a ticking time-bomb. Mind you, your Dragon was a ticking time-bomb too. Neither of the two engines are known for reliability. However, if the engine holds together, you made the right move. The only thing you are going to miss from the polaris is the...

Pro's Once tuned and properly setup you won't go back because it is way too much fun wheeling up the hill past the stockers Cons Need to send ECM to doo racing to move rev limiter because the twins run sweet 8500-8700rpm The extra rpms are probably not going to help the already weak cranks They...

Peregrine Helicopters $500 from Bell

I have been using Camrose airport for a few years. Need your own drum though. 780.678.5226

Spot junior a couple grand and get him into a rev chassis. Everyone will be waaaaaay happier in the long run. I assume this is the zx.

If I was buying, I'd be looking at Bogger's. $4500 and 3 months warranty, worst case in the future she'll need some bushing here and there.

Thanks Slomo and pipes! If plans change I will let you know. Steve from Adrenaline tours contacted me and he will bring it to Edmonton on Friday. Huge thanks to Steve and the people he wrestles into helping him get it up onto his sled deck. Thanks again, very much appreciated!

Me too! Wrecked the sprag on my recoil, Clint and his dad (I think) fixed me up with a new one and a warm place to install it. Met up with him at the Griz later that evening, had a few drinks and a lot of laughs! Thanks for the help. And Clint if you're reading this, Keep on Shampooing Brother!

Spent this past weekend riding crazy deep powder. The conditions were so good that we decided to stay and ride Monday. Headed up to Bell and rode most of the day, ended up playing down in the ravine in front of the cabin. Took out a crank bearing on my XP and spent 3hrs trying to get it out. Ha...

Newbie on 4 stroke = Point, Shoot and Shovel The pattern goes on forever or until your back gives out!