Recent content by m7 carver

Rode allen today, snow got deeper as we went back. We got just passed super bowl and there was about two feet of fresh. It was great until our buddy broke his ankle.

My 2006 m7. Its got 7300km. Put a new topend in at 6500 just for pm and compression wasnt up to par. Been a great sled. mods- mbrp can, simmons skis, two wheel kit, rk-tek clutch kit, 09 seat, bdk intake.

16500??? Obviously dont want to sell it too bad!

just finished polishing my tunnel, i used the polish that is used for big trucks and i got it at frieghtliner in edmonton.

i dont see 417lbs dry and belt drives on doos...

I think it is the 07s and up that have the spacer that you can flip around right behind the secondary bolt and then you just screw it back in and it spreads the shivs.

I dont know for sure if i lost any top speed. ok, i got it set right in the middle at the moment but will probaly play with it a bit once were in the hills. thanks for the info

Around Sicamous i would go to Blue Lake, ive never been there but have frinds who love it. Also Owlhead in Sicamous is another great place, ive been there. In Blue river ive ony rode Red Sands and it was great, it would have been better if it was sunny but it was steep and deep as they say!

Like to push the helix in to get the belt on, i got it on and tried i out today and it seems to work good but just wondering?

I installed an rk-tek clutch kit on my m7 tonight and am wondering why it seems so tight? Is this normal? I have the grey coloured spring and it has green markings on it. Any comments would be appreciated!

my cylinders are honed and they are nikasil coated, just did the top end on mine and we ran a hone through it just to make sur ethe rings will seat

What do they cost?

I would check and make sure your powervalve cables are not un hooked, we had this problem whne we bought my m7 and one of the powervalve cables was un hooked.

You guys are saying a M7 should only rev to 7800? What wieghts are you guys running in yours?

Just wondering if anyone has tried to put the m7/m6 suspension in the 2009 rails? I kinda doubt it because the suspension in a 2009 is a fair bit different.