Hi and thanks for any information to all who can help.
I have a 2010 600 RMK 155 with electric start and reverse. Sled is all stock with no mods. Was riding out on the trail this past weekend and noticed that the speedo/tach/coolant display was out. Sled was running good all day until this time and was still running good without the guage. Stopped the sled and turned it off to check under the hood for wiring disconnected or burnt and nothing found. Started the sled back up and the digital display came back on and worked for a few more kilometers. Did not check the head lights or tail light at the time the gauge read one bar. Watched the display and noted that the voltage level dropped to one bar and the battery was flashing and then the display went back off. Sled still ran ok other wise back to loading area. Again turned sled off and restarted to load onto trailer, and once again the display came back on. Checked for burnt or shorted wires last night and none found and confirmed that the head lights and tail lights are working. Started sled and let is idle till normal operating temp and not a problem with the display. I have read about updated voltage reg being on the belt cover and this sled already has the voltage reg in this location from factory. Am going to check stator output tonight. Thanks for any help.
I have a 2010 600 RMK 155 with electric start and reverse. Sled is all stock with no mods. Was riding out on the trail this past weekend and noticed that the speedo/tach/coolant display was out. Sled was running good all day until this time and was still running good without the guage. Stopped the sled and turned it off to check under the hood for wiring disconnected or burnt and nothing found. Started the sled back up and the digital display came back on and worked for a few more kilometers. Did not check the head lights or tail light at the time the gauge read one bar. Watched the display and noted that the voltage level dropped to one bar and the battery was flashing and then the display went back off. Sled still ran ok other wise back to loading area. Again turned sled off and restarted to load onto trailer, and once again the display came back on. Checked for burnt or shorted wires last night and none found and confirmed that the head lights and tail lights are working. Started sled and let is idle till normal operating temp and not a problem with the display. I have read about updated voltage reg being on the belt cover and this sled already has the voltage reg in this location from factory. Am going to check stator output tonight. Thanks for any help.