Recent content by Tsalmo

If fuel pumps not it could be the stator, I had this happen to one of my sleds the ground on the the stator was loose/broken and it slowly got harder and hard to start ran fine when you got it to start but sometimes itd take 10-20 pulls to start.

I soaked it with brake cleaner and wiped it down with some towles to remove any left over oil film, Im not sure how much made it in there either. When I figured out the cap was off it was still running fine so I tipped it over for 15 mins then kept riding it took a good 30 mins after that till...

Hey guys, I have a 08 M* and long story short the oil cap was forgotten off and i got some oil down the little hole above the stator. When i was riding it started sputtering and my speedo was going nuts. I shut it off and haven't been able to start it since. What could it be i pulled my rewind...

I have a 08 Crossfire 800 and did a "M8" conversion( not exactly a M8) changed the track, drive shaft with drivers, M8 skis that's all you need to get the bigger track but you can change the gearing and clutching to match better

I have always done new rings, pistons, and seals between 2000-3000 miles do a compression check and see what that's at, it'll tell you for sure whether or not it needs to be done but if i was you I'd do it before it's to late!

Could be your recoil that how my dads was before his recoil went out sounded like marbles bouncing around

I was thinking about getting a clutch kit for my sled stumbled upon the speedwerx clutch kit. Has anyone tried these kits yet if so how do they work? If not what clutch kit should I get? Thanks in advance

I have one on my 08 and I like it, I did get a killer deal on it though and so far I like the sound not as deep as I would like but it was $75. If I was going to buy a brand new one I would defianly get a MBRP they sound the best IMO they are deep and throaty but are a lot louder.

Brainerd

Just to let you guys know this upgrade doesn't work in a 08 XF

The bearing I picked up is 17 inside bore 40 OD 17.5 wide and is a double roller so should be the same as what you guys are putting in right? and I have never owened a cat with the DD but had the skid, drive shaft, and DD tore out in 2 hours these sleds are super easy to work on! I just hope its...

I opened up my DD and the bearing was junk bought the 6203-2RS bearing hoping to put it back together this weekend. Just wondering if there is anything to watch for when reassembling or just slap it back together?

Craigslist there are about 3 on Minneapolis Craigslist for $300-200

How's it going everyone? New to snow and mud been riding sleds and wheelers for 15 years now. Current rides are 08M8/CF and a 08 LT-R 450.