If fuel pumps not it could be the stator, I had this happen to one of my sleds the ground on the the stator was loose/broken and it slowly got harder and hard to start ran fine when you got it to start but sometimes itd take 10-20 pulls to start.
I soaked it with brake cleaner and wiped it down with some towles to remove any left over oil film, Im not sure how much made it in there either. When I figured out the cap was off it was still running fine so I tipped it over for 15 mins then kept riding it took a good 30 mins after that till...
Hey guys, I have a 08 M* and long story short the oil cap was forgotten off and i got some oil down the little hole above the stator. When i was riding it started sputtering and my speedo was going nuts. I shut it off and haven't been able to start it since. What could it be i pulled my rewind...
I have a 08 Crossfire 800 and did a "M8" conversion( not exactly a M8) changed the track, drive shaft with drivers, M8 skis that's all you need to get the bigger track but you can change the gearing and clutching to match better
I have always done new rings, pistons, and seals between 2000-3000 miles do a compression check and see what that's at, it'll tell you for sure whether or not it needs to be done but if i was you I'd do it before it's to late!
I was thinking about getting a clutch kit for my sled stumbled upon the speedwerx clutch kit. Has anyone tried these kits yet if so how do they work? If not what clutch kit should I get?
Thanks in advance
I have one on my 08 and I like it, I did get a killer deal on it though and so far I like the sound not as deep as I would like but it was $75. If I was going to buy a brand new one I would defianly get a MBRP they sound the best IMO they are deep and throaty but are a lot louder.
The bearing I picked up is 17 inside bore 40 OD 17.5 wide and is a double roller so should be the same as what you guys are putting in right? and I have never owened a cat with the DD but had the skid, drive shaft, and DD tore out in 2 hours these sleds are super easy to work on! I just hope its...
I opened up my DD and the bearing was junk bought the 6203-2RS bearing hoping to put it back together this weekend. Just wondering if there is anything to watch for when reassembling or just slap it back together?