Where to get TPS set in Edmonton Area

dmax_silvia_s13

Active member
Joined
Dec 10, 2009
Messages
29
Reaction score
17
Location
Whitecourt, Alberta
I just purchased a 2010 dragon 800 and it ran fine when I picked it up but now it idles low and stalls when I put it in reverse so I assume the TPS is out. I was thinking about building my own tool to set it but If I can get it done by someone with experience for cheap I would rather do that.

So the question is where is the best place to get this done around Edmonton/Sherwood Park?
 
  • Thanks
Reactions: ice

dmax_silvia_s13

Active member
Joined
Dec 10, 2009
Messages
29
Reaction score
17
Location
Whitecourt, Alberta
Now that I am running the sled a bit more I realized another problem. When the sled is a bit warm and I shut it off it does not want to start again after that. I have to give it some fuel while pulling it over and it most of the time starts then. And the Low idle and stalling while putting it in reverse has gone away.

Any insight?
 

dmax_silvia_s13

Active member
Joined
Dec 10, 2009
Messages
29
Reaction score
17
Location
Whitecourt, Alberta
There is no freeplay in the throttle cable. Any other ideas? I am going to pick up some plugs tomorrow. Do you think this is all caused by the tps?
 

dmax_silvia_s13

Active member
Joined
Dec 10, 2009
Messages
29
Reaction score
17
Location
Whitecourt, Alberta
Sorry I am actually located in Sherwood Park now I just have not updated my location.
I decided to take the $110 hit and am taking it to Cycle Works on Saturday.
 
Top Bottom