spec for tps

[jimjim]

does any one no what the volts for my tps is for the closed and idle Position
is it the same as the 08s .70=+/- .01 for closed and idle is .93+/-.01

 

[Rhodesie]

does any one no what the volts for my tps is for the closed and idle Position
is it the same as the 08s .70=+/- .01 for closed and idle is .93+/-.01

8,9,10 all same. try to get the idle @.937 or .942 volts.

 

[jimjim]

Ok I did the .70 at closed but when I set the idle at .93 and start it it idles at 2400 even after it warms up

 

[Rhodesie]

when you set it you had the cable unhooked from the flipper? if so it sounds like its sucking air in some where. pto crank seal? spray ether in short bursts around the seal and see if the rpm changes.

 

[jimjim]

ya i did have the cable off
ok ill go get some ether and give it a spray thx for all the help