Snorkle body panel fitting issues

[Octane]

just installed my SYA kit and im having issues gettting the dash panel on the right side to seat properly, its about 2 inches above where it should be.
just curious if anyone has had any issues like this?

Thanks
Octane

 

[jncmcat]

Disconnect the wiring harness from its holder and bend it out of the way, thats how I made the kit fit, even then it was very tight. I actually changed to the brp snorkle set up, works pretty slick, truth be known that if you were to go into water where it was deep enough for only your snorks to stick out, the quad will float up on the front quite easily. I just noticed you are running a Rene, mine is a Outty so good luck, you just need to be creative sometimes. Check out the wild boar rad relocate for the Rene also.