Slp torque arm

[sledneck_03]

Who has one of these? Did you adjust your clutch alignment after? Notice better belt and motor mount life?

 

[ditch1000]

I have one, my dealer adjusted the clutch alignment after I installed it last year during my preseason service. I always have had great belt life on my sled; either way I think it is worth the money, if nothing else to put less stress on the motor mounts.

 

[sledneck_03]

Took pipe and can off. Did not take off primary or y pipe.

Intalled bracket and two bolts into block with loc tight.

Then installed arm with loc tight but didnt tighten.

Put u-bracket on frame. Spun arm till i could barely install bolt threw u bracket then tightened bolt and nut till tight.

Tightened bolt threw rubber end.

Tightened jam nut mid arm.

Seems like when the u-bracket crushed it would loosen up but it didnt. Not sure if i was suppose to crush it but bolt had alot of threads so i thought best to not have the u-bracket pulling on threads in shear, better to pull on shank.