$280.00 for kit includes all hardware and detailed instructions. If in edmonton area we will install. Kit and install is $380.00.
What size? It looks like 1 1/2 inch pipe.....
You are correct.
tabneil, I like your snorkels for the outty, I use a 2" on the intake side, catching both cvt and airbox on my 500. Ran my set up a couple weekends with no problems, no lack of air, no robbing power from the engine. Had my outty in some slop over the racks no problem. I use a 2" on the cvt exhaust as well, have flipped over in some water an taken some water in the belt, rev up and watched that 2" pump out full bore. I know its a little risky 2-1 the intake side, but I also added the crank breather and relocated it under the dash, had another buddy try this with out moving the crank breather and when he rolled on his side he got oil from the engine into the cvt, bad deal. One thing that is advisable is to upgrade the air filter to the double foam filter, it can handle a little water, it will catch most of the water if any enter the air box.
Did you just run the intake snorkel for the motor off the stock intake with a 1 1/2 rubber coupler??? I had done mine like this but found I was running rich. 280 seems a bit high for 60 bucks of pvc pipe and connectors.
personally i think a 800 needs 2" intake for the engine. another tip is that a valve stem is insuffient in my experience, a little bit of dust and dew in the airbox and that small hole is plugged up and wont drain, even crud in the water blocks it( never seems to be clean water in there lol)
i have done prob 30 can-am snorkels this year, just a few things i've seen and heard back on.