SHREK1
Active VIP Member
Need a little help here , just bought a 79 ford bronco and its got a 400 in it , the oil pan is cracked . need to replace it but can't find one . any idea's anyone
need oil pan for 400 ford 4x4
- Thread starter SHREK1
- Start date
OVERKILL 19
Active VIP Member
Weld the crack!
- Thread starter
- #3
SHREK1
Active VIP Member
iT HAS BEEN WELDED ALREADY , IF CAN'T FIND A NEW ONE THEN I WILL WELD IT
CATPRIDE
Active VIP Member
Dorman products. If you need one pm me the year make model of the engine.
- Thread starter
- #5
SHREK1
Active VIP Member
puuled it off and rewelded it was just a poor weld job , if this don't hold will pm you
grizzly se
Active member
400 ford / cleavland 351 same no ?? I have lots of cleavlands
- Thread starter
- #7
SHREK1
Active VIP Member
400 ford / cleavland 351 same no ?? I have lots of cleavlands
351m is the same , not sure about the cleavland
Uturn
Active VIP Member
If you need parts, I have a few from a 78 1/2 ton. Factory pushbar, windsheild, Weiand dual plane intake manifold, chrome grille, 351M, etc.
Similar threads
