Turblue
Active VIP Member
I can't seem to get the coolant circulating through the tunnel coolers……..what am i missing? Is there a bleed screw somewhere? I don't have the radiator on mine, just a coolant bottle with the pressure cap
I can't seem to get the coolant circulating through the tunnel coolers……..what am i missing? Is there a bleed screw somewhere? I don't have the radiator on mine, just a coolant bottle with the pressure cap
Bleeding the cooling system on a Nytro MTX is relatively simple.
There is a bleed fitting located on the right hand side of the sled. The best way to find it is to fallow the hose that is connected to your front heat exchanger on the right side. The bleeder is kinda hidden on the right side between the motor and sled frame assembly and radiator up top.
Once you found the bleeder, remove the cap and fill the cooling system till its full. Raising the front does help in this preceedure.
Once the system is full apply vacuum by using a length of 1/4" hose either by sucking or using a shop vac. I use a shop vac.....haha
Keep filling the filler till you get a steady flow from your bleeder hose.
Once satisfied, put cap back on and top up, run machine till warm. Retop and your good to go.
The whole precedure shouldn't take more then 15-20min.
Hope that helps, BTW i have the same setup, rad delete and CR extreme running boards with CR U-cooler.