Search results

https://www.cfact.org/2021/03/17/fake-invisible-catastrophes-and-threats-of-doom-patrick-moores-outstanding-new-book/?fbclid=IwAR3YxKxBNYHvyk_LhrNoJjKXNuWuo5k__diSK4Uf26XIisgOrXfJoTp-hSE

2013 xm I get an over rev indication when descending if I pick up the rpm enough to engage the belt. Happens consistently. Anyone else experience this? Big pain to take it to a dealer with only very limited days to ride due to work. ok to ride?

Looking for a little assistance. - 2013 800 xm Cooling - I have the temp gage. Runs just past half and with any work will show all bars. Always do something to improve cooling when this happens and have not got a light or overheat shut down yet. Appears not to cool as well as I had hoped or...

Regarding the motorized closed area in Airy (Norns range). There is a hut in this area called the Shaker Hut. It has been there for quite sometime and was traditionally used by hikers and climbers in the area. There was a commercial snowcat operation in there for a few years who built a road...

There is a widespread layer of surface hoar buried around the 28 - 29 of dec. - things are changing. Critical loads are in the forecast with wind and warming temps. Its going to go from really good to really scary. Will the sledding community respond?

Another avy accident in the 100 mile area. Recovery underway. Please be careful this weekend. Conditions have changed significantly in the past few days. Critical loads exist on a number of weak layers in the snowpack.Temperatures are warming. Avoid avalanche terrain for the next few days.

Looking to purchase a truck. I have been a gm fan and had good luck with the past few but want a quad cab 3/4 ton and thinking of putting a light camper on it but would like to stay with a short box. The gm q cab short box will not take most campers. Looking at a Dodge. Won't be new, a couple of...

I've got the motor out and the welds are cracked on the plate that the back two motor mounts sit on. Just the three back welds where it meets the tunnel. All the other welds are fine and I cannot move the plate. The bottom of the steering column is also attached to this plate. Has anyone seen...

I'm working on a 98 summit. I've got the motor out and the welds that attach the plate that the back motor mounts sit on to the tunnel are cracked. There are three welds on the back of this plate about 10 cm long each. They are all cracked. The plate is well attached on all other sides with no...

I'm looking to rebuild the motor in a 98 670x. Its stock now and still running great but lots of kms. I want to keep this motor stock (reliability) as it does all we need it to. My local shop is average at best and I'm not that keen to give them the business if I can find a good recommendation...