Search results

I have the Can Am Alpine Flex Plow, best plow out there, super easy to hook up and take off by pressing the foot pedal. The springs are heavy duty so you can push a lot more snow than your standard steel blade. Well worth the money!

Hey all, just picked up a 2013 XMR 1000. Can't wait to get out and about with this beast!

Got my rails anodized at Anderson Anodizing and it cost $120 for the pair...

I would take extra fuel if I were you...can never go wrong, especially if you ride hard...or get stuck a lot :beer:

I plastic welded mine and it has been rolled a few times and the weld is holding strong....

Just put a new Y-pipe on and had a leak on the doughnut, sealed it up with Ultra Copper and no more leaky....can't go wrong with the stuff

What did you use to cut it?

Mine would backfire too after I would run full throttle or a hard pull without idling for a bit....let 'er calm down for a little bit before hitting the kill switch.

Put a hook in the middle and haul it there...you'll have no issues.

looks like an alien

I think it is a knock sensor failure...could it possibly have had bad gas in it? or stale gas? Has the ECU been replaced? I think the ECU's were updated to take care of that code.

x2 on the Klim....awesome boot

Awesome pics! Looks like it was a great time....can't wait!

If it is repairable just plastic weld it....

Here's my 2008 M8 Cat wrapped up......

Awesome Vid!:specool: Welcome to S & M!!

This is where the dealership installed mine..... 2008 M8.....

Lime Nine

Welcome to S&M!!

Welcome to S&M!! Can't wait to see some sweet vids!