Recent content by olymon

  1. O

    Clutch sheave

    Curious to hear what the face run out is when it's bolted on a motor and a dual indicator is put on it. Pull plugs and turn it over. Did you make a fixture to hold the taper? Riding old sleds
  2. O

    Mmmmm Beer

    Shorts "good humans" and some brownies. Too bad they only sell it in and close to Michigan Riding old sleds
  3. O

    And another G4 bulkhead gone..

    Kind of an off the wall question, do the lynx sleds come in a G4 type of platform. Those lynx were always overly built like tanks. Any idea if they have been having bulkhead issues if they are the same G4 type platform. I suck at searches like that, anybody got any info. Riding old sleds
  4. O

    What have you needed to do to get off the hill?

    I like the idea of turning the skis around on the tow sled. Riding old sleds
  5. O

    2018 - why pick the freeride?

    A good portion of the weight difference is the SHOT starting system (-20 lbs.) on the summits but not on free rides I believe. Riding old sleds
  6. O

    Marvel Mystery Oil?

    Additive to oil or gas, not a replacement for oil. Riding old sleds
  7. O

    2002 600 steering issues?

    Maybe there is a way that the pivot on the bottom of the bar post has somehow got to a point that the pivot point has flipped the rod to the wrong side. Shine a light down in the belly pan and look if something looks really out of place. Doubt it, but worth a look Making JIS screws into junk
  8. O

    J.B. Weld original

    Pipe plug taper puts more stress on it when tightened and could actually crack it easier. Just drill and JB welds it. Making JIS screws into junk
  9. O

    Plastic doo hickey ??

    I bet that they put that on so they only have to change part of the cord to put another connector on to fit another countries power socket to it. Making JIS screws into junk
  10. O

    What does everyone do for a career?

    Strain gage based stress analysis. Anything from weighing an egg to a 250k load cells for NASA. A lot of automotive and agricultural parts for testing. Making JIS screws into junk
  11. O

    Poor mans sled deck.

    I had a similar set up on a little nisan pick up, but mine was the height of the wheel well tops. Made the approach angle to load a lot lower. Would your deck fit between the box sides? Making JIS screws into junk
  12. O

    100 year thought experiment

    Oh, no, not quite.... Just look up the condoms of old days. Not quite the same a today. Making JIS screws into junk
  13. O

    Walking Dead....WTF

    Any body pick up on that little line where negan says to the guy ready to kill Darrel. He stops him and then says something like wait til you "try it" . Sounds like Darrel is getting set up for a little forced back door action from those guys Making JIS screws into junk
  14. O

    Why are all carbide runners built the same?

    There is a company out there that makes a wear rod with rectangular piece of carbide in it. As the rod wears around it you end up with a tall deep carbide chunk that is only about 1/8th" wide. Not razor sharp, but because it is such a slim profile it bites good. Maybe search self sharpening...
  15. O

    Cooked Regulator/Rectifier on 88 700 Grizzly

    I know a lot of guys over on the honda twins motorcycle forum are using a john deere lawn tactor regulator/rectifier. I did the swap on a old motorcycle my wife has, seems to work fine. A search should come up with the swap and part number. Sent from my PC36100 using Tapatalk 2
See more
Top Bottom