Recent content by kentz

Thanks Boobage, if your free Dec 20 for a ride email me. Kent

PM'd you.

Hi all, I am looking for some info on the riding areas around Lumby. It looks like there are a couple areas like Park Mountain Range, the Pinnacles, Monashee Mountains, and Silver Star. I found a crude map on the Monashee tourism website but directions were limited. Can anyone help me out...

Man is that a great step by step procedure, great work, thanks a lot Paul27!

Thanks Paul27, once again your bearing knowledge boggles my mind. Do you work for a bearing company or are you a machinist or something? I think ill just take all the part numbers you've listed in your posts and take that info down to Commercial Solutions and see what they have in stock. Thanks.

Thanks guys

Hey Paul27 thanks for the in depth response. Unfortunately I already ordered one off of the internet from the states based on a link in this thread. Looking back it is probably a piece of crap since it was $8, it looks identical to the BDX one that they are charging $15 for so I figured it was...

Ok thanks, I talked to Cutler yesterday and they advised it would be a pain to install with the skid plate and it would be best to remove the skid plate. The frogskin elements won't stick to the skid plate plastic very well. So I think I will just leave it stock for now, not worth the risk of...

Has anyone used the Cutler intake on a 09 M8? The system looks nice but I am worried about having exposed intakes in the nose cone of the sled. If anyone has used this setup I would like to know how the intakes hold up to tree bashing and such. I also have a full skid plate on the sled so not...

Thanks.

Thanks ill give it a shot. Is it possible to change this bearing by just removing the case cover without removing the whole DD unit?

So should I buy the BDX complete kit, the BDX 5203 bearing by itself or just the 5203 bearing from a local bearing shop where its probably cheaper? There are two 5203 bearings listed as well, a 5203-2RS which is a sealed bearing (looks like the BDX bearing) or a 5203-ZZ which is a shielded...

Nope I love them, going to buy a couple more pairs. Great lens quality, like any goggle they will fog up if you get them wet, so I carry a couple pairs. Back to back with my Oakley goggles last weekend in the fog and there was no comparison, the 509's were better.

Thanks for the Lumby update. I am in Oyama, maybe I'll give it a shot next week and see what its like. I am surprised it is 20 minutes farther than driving to Hunters. On the map it looks like it should be closer to my house? Where is the staging areas for Park and Nelson? Thanks.

How is Lumby? Like Hunters?