Turts
Active VIP Member
Folks, I want to make a tool to keep the upper gear and sealing washer in place while removing the secondary shaft.
I'm thinking a piece of stock turned to just under the OD of the shaft as it fits into the bearing. Also turn the end into a threaded stud same threads as the upper gear retaining bolt.
Here's the problem. I'm not anywhere near my sled.
Anybody have there shaft out?
And can get me some measurements?
Or, other suggestions? I tried using a socket and extension but that didn't work too well for me.
Sent from my iPhone using Tapatalk
I'm thinking a piece of stock turned to just under the OD of the shaft as it fits into the bearing. Also turn the end into a threaded stud same threads as the upper gear retaining bolt.
Here's the problem. I'm not anywhere near my sled.
Anybody have there shaft out?
And can get me some measurements?
Or, other suggestions? I tried using a socket and extension but that didn't work too well for me.
Sent from my iPhone using Tapatalk