Question about taking secondary off of 14 xm

[sledder325]

I want to take my secondary clutch off just wondering what size of socket i need to take the nut off of the jack shaft on chain case side, and also what should i torque the nut when putting it back together, its a 14 xm skidoo.

 

[250mark1]

are you looking to take it off with the chain on or off ski doo makes a tool that goes in where the rubber plug is to hold up the sprocket and chain so you do not have to drain the oil and remove the cover
if you remove the chain case cover you do not need any special tools to remover the secondary and shaft

 

[sledder325]

I will be taking off the chaincase cover as i need to change the oil as well, i have the tools to take the helix and spring off not the other tool to hold the chain and sprocket but thats ok, just wondering what size socket and what to torque the nut to.

 

[Caper11]

It's either a 16 or 17 mm and I think the torque is 38ftlbs.


Sent from my iPhone using Tapatalk

 

[revbyu]

Its 17 mm

 

[lsone]

17mm and 38ft lbs, use the parking brake to loosen and torque. DO NOT torque with the chain case cover off.

 

[pfi572]

"DO NOT torque with the chain case cover off."

Why would this be?

 

[Caper11]

Id like to know the answer to that as well?


Sent from my iPhone using Tapatalk