walleye101
Member
Just wondering if anyone has added some pin weight to their sleds for low elevation? I have a buddy that had a BRP Low Elevation kit in his 2013 Summit 146 and took it out and put a DJ kit in. I picked it up from him for super cheap and hear how the BRP kit is not the greatest. I have a 2014 Summit 800 146 and wondering if i could just add that pinweight of around 19 grams and run the 441 ramps and original primary spring? I heard the 413 ramps don't work as well as 441s?? I also noticed the forces are quite low on the yellow/green low elevation primary spring. Just wondering if anyone has tried this set up and how it's worked? I live around 1600-2200 elevation and need something better for here then the sock clutching so i don't have to run clicker 1 and still come close to rev limiter. I plan on purchasing a DJ or Rooster built kit but probably not this season as we haven't ridden much and no good snow conditions here. Thanks for anyones input and hope someone has tried a setup like this.