Search results

Mag side solenoid has a hose on it that is too big of ID compared to the solenoid nipples OD. The hose has a double crimp clamp holding it onto the nipple. That entire combination can create a steady vacuum leak, enough not to fully open the Valves at high rpm over 7400 I believe, or can cause...

I have been having some issues with my sled the last year or so and I am thinking it is electrical related, but maybe something else. I would be driving along, usually on a lake or groomed trail and it would be running absolutely fine, then start to bog and not run the greatest and some lights...

www.bluhmenterprises.com

Could be leaking vacuum to your raves, not allowing them to open all the way

I have one that has 0.010" shaved off. Where are you located? Best thing to do is to measure the squish to see how much you can go, then decide from there.

Hi there, just seen you posted some codes on the Apex. I am wondering how you can get the code to come up on the display. I can get to the Di and thats it. Thanks

X2 Hopefully not though Mine did the same thing both times the engine was failing. 2007 800r Summit. First at 700 sled miles and the second at 1600 sled miles. If you ride it any more, it will probably be a big failure. My second engine was stalling going into reverse and running rough and...

12" on back, 10" on front. Make sure the offset of the rims are enough to keep the tires a little to the outside of the fenders so you don't hook fenders on the trees.

Is it for sure a bog? Could it be belt slip? I thought mine was bogging, but eventually i found the small vent on the bottom of the left side panel was letting in a little amount of snow and was slipping my belt a little. I put some duct tape over it as soon as I found the problem while out...

You can check out Gaudins in Beaverlodge, they are very helpful. 780-354-8132

I believe the 09's won't fit because the pitch is 2.86 if I'm not mistaken. You'd have to change drivers. I put a 162" on mine and used a 9" wheel kit to take up some of the slack. There are many options out there.

Pictures of skid relocation

Axle - Wheels - I will take a picture tomorrow of the current skid location from stock. And just to express how reliable it has been, I installed this early January 2008 at 1600 miles when my second engine failed. I just rolled over 4000 miles on Sunday with absolutely no problems with...

Heres some pictures of it and compared to buddies stock machine.

Avid Offset axle was also installed.

i put 9" wheels on and moved the skid back.

Zac's Tracs will be in town early Feb as well for Avy Training, maybe someone from CAC will be up as well for that time??

My buddies # is 780-882-5626 and his name is Richard. The sled has 0km on new bottom end that was replaced under warranty and has warranty until Dec 5/10. My girlfriend usually rides it and likes it way better than the sled I have for her which is a 2000 700 RMK. On it you think about leaning to...

My buddy might be selling his 08 600 155 EFI with SLP Pipe and Can, fuel rack, Pro Taper Bars, Cover. If you haven't rode one, I want to be there to watch you. It is hard not tipping them over if you are not used to the newer IQ Chasis. I have fell off and pretty much everyone that jumps on it...

did the starter fail, or just the bendix? I think you can buy a bendix from Motor Tech in Golden.