Silber Install on 2020 mountain cat

roughriders

Active member
Joined
Nov 12, 2009
Messages
112
Reaction score
140
Location
heading west
Are you guys sure Silber reflash still has a break in time, Or is the break in gone when the reflash downloaded in?

it still has the break in , make sure oil tank is topped up cause it will use most of it on first two tanks of fuel
 

roughriders

Active member
Joined
Nov 12, 2009
Messages
112
Reaction score
140
Location
heading west
well sled went back to westlock for updated flash, supposed to clean up bottom end. seemed better just driving around parking lot. will have it out this weekend again to try it

shout out to WPM , bought the kit through them and have been awsome at answering questions and getting me in and out in short order on the reflashes.

have some clutching coming this week to try also , hopefully find some snow
 

Drckohl

New member
Joined
Jan 12, 2013
Messages
3
Reaction score
0
Location
Edmonton
I have the same kit on my 19 what did you settle for clutching wise? Be mindful of the primary weights they wear quickly
 

phrynyk

New member
Joined
Dec 9, 2014
Messages
4
Reaction score
6
Location
Berta
im also curious. I picked up a kit for my 19 and want to know what guys are running in vale,blue etc..
 

roughriders

Active member
Joined
Nov 12, 2009
Messages
112
Reaction score
140
Location
heading west
running the silber weights. helix and springs from ben in edmonton. maxed out the weights to i believe 81grams. running 6.5lbs.
 

killerrf

Active member
Joined
Feb 5, 2010
Messages
147
Reaction score
55
Location
sk
running the silber weights. helix and springs from ben in edmonton. maxed out the weights to i believe 81grams. running 6.5lbs.
Any new vids of sled running? What setup for clutching u running now? I finally got my turbo installed after 2 years sitting in closet ha. Tried it around home with 100 Av and looks like it’s at 6 psi. At 2200 elevation little high boost but might be ok with full Av gas.
 

roughriders

Active member
Joined
Nov 12, 2009
Messages
112
Reaction score
140
Location
heading west
no vids of the one trip this year. i need to pull it apart as i lost my notes for what i put in at end of last year. still with silber weights, backed off to 78 grams at 6psi(give or take) ****ty gauge.
was holding 53mph on deep climbs so dont think nothing wrong with that
 

killerrf

Active member
Joined
Feb 5, 2010
Messages
147
Reaction score
55
Location
sk
no vids of the one trip this year. i need to pull it apart as i lost my notes for what i put in at end of last year. still with silber weights, backed off to 78 grams at 6psi(give or take) ****ty gauge.
was holding 53mph on deep climbs so dont think nothing wrong with that
Ok. Yea 53 seems good. Did u put a steel bottom gear on? I did. That aluminum is a pile of ****. I had 800 miles on sled when I put turbo on here and it lots of wear.
 
Top Bottom